Skip to main content

If oil has gone in evaporator then how to remove oil from evaporator of refergeration system?

1.Pump down the ref gas in condenser and close the inlet and outlet of the condenser
2.There are cock provided at the inlet and outlet of the evaporator coil

3.Open inlet and outlet of evaporator coil and blow through by nitrogen
Labels:

Comments

Post a Comment

Popular posts from this blog

Why atomisation test should not be done in slide type fuel valves

Since very small needle lift is obtained in the test equipment result in an unequal pressure distribution in the cut off shaft resulting in a hard contact in a small area along with high frequency oscillations, low lubricity of test oil will increase the chance of seizure. Full lift and high lubricity of heavy oil eliminates this risk  of seizure during normal operation.( Always open and clean slide type valves before testing as cold sticky heavy oil along with small clearances can cause restriction in the movement of the spindle).
Post a Comment
Read more