Skip to main content

maintenance done on crankcase relif door and seating pressure,type of spring used in cc door, flame mesh

Crankcase doors must be free to operate, openings of mesh should be checked and made clear. Check the sealing rings are in proper condition and not causing the valve lid to stick.  In hinge type relief
doors hinges must be free to move and lubricated at regular intervals
Labels:

Comments

Post a Comment

Popular posts from this blog

Why atomisation test should not be done in slide type fuel valves

Since very small needle lift is obtained in the test equipment result in an unequal pressure distribution in the cut off shaft resulting in a hard contact in a small area along with high frequency oscillations, low lubricity of test oil will increase the chance of seizure. Full lift and high lubricity of heavy oil eliminates this risk  of seizure during normal operation.( Always open and clean slide type valves before testing as cold sticky heavy oil along with small clearances can cause restriction in the movement of the spindle).
Post a Comment
Read more