Skip to main content

Static and dynamic balancing

A shaft is statically balanced if the center of gravity lies in the polar axis of its journals, a shaft is dynamically balanced if it is statically balanced and,when shaft is rotated in two set of bearings, the
load on both bearing must same through out the time of rotation(360 degree)
Labels:

Comments

Post a Comment

Popular posts from this blog

Why atomisation test should not be done in slide type fuel valves

Since very small needle lift is obtained in the test equipment result in an unequal pressure distribution in the cut off shaft resulting in a hard contact in a small area along with high frequency oscillations, low lubricity of test oil will increase the chance of seizure. Full lift and high lubricity of heavy oil eliminates this risk  of seizure during normal operation.( Always open and clean slide type valves before testing as cold sticky heavy oil along with small clearances can cause restriction in the movement of the spindle).
Post a Comment
Read more