Skip to main content

Trouble shooting: quantity of distilled water less than expected.


1. less heat flowing in to the evaporator
2. air ingress in jacket water in evaporator.
3.High evaporator temperature and high condenser temperature.
4.Scaling or clogging of evaporator pipes.

5.no evaporation due to loss of vacuum
6.Malfunctioning solenoid valves.
7. outside of evaporator pipes dirty.
8. condenser pipe scaling.
Labels:

Comments

Post a Comment

Popular posts from this blog

Why atomisation test should not be done in slide type fuel valves

Since very small needle lift is obtained in the test equipment result in an unequal pressure distribution in the cut off shaft resulting in a hard contact in a small area along with high frequency oscillations, low lubricity of test oil will increase the chance of seizure. Full lift and high lubricity of heavy oil eliminates this risk  of seizure during normal operation.( Always open and clean slide type valves before testing as cold sticky heavy oil along with small clearances can cause restriction in the movement of the spindle).
Post a Comment
Read more